Werbung
Verfügbare Sprachen
Verfügbare Sprachen
For your safety
WARNING!
Before using the polisher, please read and
follow:
these operating instructions,
–
the "General safety instructions" on the
–
handling of power tools in the enclosed
booklet (leaflet
the currently valid site rules and the
–
regulations for the prevention of acci
dents.
This polisher is state-of-the-art and has
been constructed in accordance with the
acknowledged safety regulations. Never
theless, when in use, the power tool may be
a danger to life and limb of the user or a third
party, or the power tool or other property
may be damaged. The polisher may be
used only
used as intended,
–
in perfect working order.
–
Faults which impair safety must be repaired
immediately.
Intended use
This polisher is designed
– for commercial use in industry and trade,
– for all types of polishing work with polis-
hing sponges, lambskins and woolskins,
felt plate, buffing disc,
– for use with polishing tools which are per-
mitted to run at a speed of at least
7400 r.p.m.
Safety instructions for polishing
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries . Keep all safety instructions and
other instructions in a safe place for the
future.
14
no.: 315.915),
-
This electric power tool must be used as
a polisher. Observe all safety information,
instructions, diagrams and data which you
receive with the power tool. If you do not
observe the following instructions, an
electric shock, fire and/or serious injuries
may occur.
This electric power tool is not suitable
for grinding, sanding, for use with wire
brushes or for cut-off grinding. If the
electric power tool is not used as
intended, the user may be exposed
to hazards and may be injured.
-
Never use accessories which the manu-
facturer did not intend or recommend
especially for this electric power tool. Just
because you can attach the accessory to
-
your electric power tool does not
guarantee safe use.
The permitted speed of the insertion tool
must be at least as high as the maximum
speed indicated on the electric power tool.
An accessory which rotates faster than
permitted may shatter and fly off.
Outer diameter and thickness of the inser-
tion tool must correspond to the dimensi-
ons of the electric power tool. Incorrectly
measured insertion tools cannot be
adequately shielded or controlled.
Flanges or other accessories must fit
exactly on the spindle of your electric
power tool. Insertion tools, which do not
fit exactly on the spindle of the electric
power tool, rotate unevenly, vibrate
violently and may result in loss of control.
Do not use any damaged insertion tools.
Before use, always check the insertion
tools for splinters and cracks. If the electric
power tool or the insertion tool is dropped,
check for damage or use an undamaged
insertion tool. When you have checked
and inserted the tool, ensure that you and
anybody in the vicinity remain outside the
plane of the rotating insertion tool and
leave the power tool running for one
minute at maximum speed. Damaged
insertion tools usually break during this
test time.
XFE 7-12 80
Werbung
