Sundstrom H06-2012 Gebrauchsanleitung Seite 48

The PPE Regulation (EU) 2016/425 type approval has
been issued by Notified Body 2849. For the address,
see the reverse side of the user instructions.
The ATEX type approval certificate have been issued by
Notified Body No. 2804, ExVeritas ApS.
The IECEx type approval certificate have been issued
by Certification Body: ExVeritas Limited.
The EU declaration of conformity is available at www.
srsafety.com
UKCA
UKCA Type-examination in agreement with Regulation
2016/425 on personal protective equipment as brought
into UK law and amended have been issued by UK
Approved Body No 0194, INSPEC International Ltd, 56
Leslie Hough Way, Salford, Greater Manchester, M6
6AJ, United Kingdom.
UK Type-examination in agreement with Equipment
and Protective Systems Intended for use in Potentially
Explosive Atmospheres Regulations 2016 have been
issued by UK Approved Body No 2585, Ex Veritas
Limited.
The UKCA declaration of conformity is available at
www.srsafety.com
Australian StandardsMark
The fan SR 500 EX is tested and certified to comply to
AS/NZS 1716:2012. The StandardsMark is issued
under licence by SAI Global Certification Services Pty
Limited Lic No.766 (ACN 108 716 669) ("SAI Global").
EX-codes:
SR 500 EX combined with hoods SR 520, SR 530,
SR 561, SR 562, SR 601, SR 602, face shield SR 570
or full face mask SR 200 with glass visor:
II 2 G Ex ib IIB T3 Gb
II 2 D Ex ib IIIC T195°C Db
Ta = -10°C to +40°C
SR 500 EX combined with face shield SR 540 EX,
helmet with visor SR 580 or full face mask SR 200
with PC visor:
II 2 G Ex ib IIA T3 Gb
II 2 D Ex ib IIIC T195°C Db
Ta = -10°C to +40°C
Key to EX markings
ATEX Explosion protection mark.
ATEX Equipment group (explosive atmos-
II
pheres other than mines with fire damp).
ATEX Equipment category (2 = High level of
2 G
protection for Zone 1, G = Gas).
2 D ATEX Equipment category (2 = High level of
protection for Zone 21, D = Dust).
Ex Explosion protected.
ib Type of protection (Intrinsic safety).
IIA Gas group (Propane).
IIB Gas group (Ethylene).
IIIC Dust material group (zone with conductive
dust).
T3 Temperature class, gas (maximum surface
temperature +200°C).
48
T195°C Temperature class, dust (maximum surface
temperature +195°C).
Equipment Protection Level, gas (high
Gb
protection).
Equipment Protection Level, dust (high
Db
protection).
Ambient temperature limits.
Ta
8. Extended guarantee
The manufacturer of the SR 500/SR 500 EX and
SR 700 fan units, Sundström Safety AB, hereby
guarantees the end user the right to within 60 months
or 5,000 operating hours from purchase – whichever
occurs first – at no cost have rectified faults caused
through defects in design, materials or manufacture.
This extended warranty does not apply to excessive
wear and tear or for a product that has been modified,
neglected, exerted to external forces, undergone
none-authorised repair or service, or has been used in
violation of the manufacturer's warnings, limitations,
recommendations or other directives. These directives
state, among other things, that the fan units must be
fitted with manufacturer recommended original filters,
that is to say Sundström's particle filter SR 510, particle
filter SR 710 or gas filter in combination with particle
filter SR 510. The guarantee does not apply to
batteries/battery charger or head-tops and other
accessories.
Guarantee service
In addition, the validity of the extended guarantee is
dependent on guarantee service being carried out by
the manufacturer or a service partner authorised by the
manufacturer. This service must be performed 12, 24,
36 and 48 months after purchase. In good time before
the time for the desired guarantee service, the
manufacturer or place of purchase must be contacted
for information concerning applicable procedures,
scope of service, delivery address, etc. Whoever
desires to claim the right to free repairs in accordance
with this guarantee shall send the product in its original
packaging with freight paid to the manufacturer's
address together with a written description of the fault.
Documents proving date of purchase, place of
purchase and guarantee service already performed
must also be attached. Products that have not
undergone guarantee service as above and as such
are not embraced by this extended guarantee shall be
covered for a guarantee period of 12 months from the
date of purchase or for a longer period as prescribed
by law.
9. Worn-out products
Information on hazardous substances
The products do not contain any hazardous
substances.
Handling of worn-out products
The battery should be removed from the fan unit and
sor ted as battery waste. A worn-out battery can be
handed in to the retailer or to a recycling centre at no
cost. The fan unit is sorted as electrical waste. The
battery charger is sorted as electrical waste. Recycle
in accordance with local regulations. Proper recycling
of products contribu tes to efficient use of material
resources and reduces the risk of spread of
hazardous substances.