Initial Operation; Basic Settings; A) Select Id Device; Time Settings - VOLTCRAFT Energy Logger 4000 Bedienungsanleitung

9. Initial operation

Do not exceed the maximum permitted input values.
Before measuring, check the measuring device for damage such as cuts, cracks or squeezing. A
defective device must not be used. Mortal danger!
Before using for the first time, the enclosed buffer battery be inserted for the time and date. Inserting and changing the
battery can be found in Section „Maintenance and Cleaning".
After inserting the buffer battery, connect the measuring device in a standard protection socket. The measuring device
is ready for programming or operation.

10. Basic settings

After the first use, some parameters must be preset to allow a correct display. You can reach this mode by pressing
the „MODE" and „Continue" keys (7) for at least 5 seconds simultaneously. This key combination also deletes the
measurement value memory in the device (reset). Hold down on both buttons, keeping them pressed down, until all
symbols are shown in the display. After releasing the keys, the menu item "Select device ID" opens.
Save and delete the data memory before every measurement series.

a) Select ID device

This equipment ID number allows you to administer up to 10 electrical users on one meter unit. In the adjustment
mode the ID number blinks in the right upper display. Choose the desired identification number (ID 0-9 with the but-
tons "min" (3) and "max" (4) and confirm your choice with the button "MODE" (5). The machine will then send you
automatically to the next mode, "time setting."
The device ID is required to allocate the measurement data in the software. It must correspond to the currently re-
corded ID when reading data in the software. Only one device ID can be recorded. Once data transfer is complete,
another ID can be selected to differentiate the data for different users in the
b) Time settings
First you select the the desired time format (12/24-h system) with the two arrow keys (3 and 4) and confirm your
selection with the „MODE" key (5).
Select the date format with the two arrow keys (3 and 4). Available are:
dd.mm.yyyy for day/month and year or
mm.dd.yyyy for month/day and year
Confirm the selection by pressing the "MODE" (5) key. You will automatically reach the next mode.
The hours display of the time flashes. Set the correct time with the arrow keys (3 and 4). After entering the hours, you
reach the minute input by pressing the „Continue" arrow key (7). Repeat these steps until you have set day, month
and year.
Confirm your settings in the year mode by pressing the "MODE" (5) key. The time starts to run and you automatically
reach the next mode.
26
software.