Characters In The Displayed Order; Basic Functions; Making A Call; Receiving A Call - Pentatron TF 03 Set Bedienungsanleitung

Delete/mute [42]
C/
to return to the previous menu; to mute the microphone during
a call; to delete an incorrect input
Navigation keys/further functions [43]
up/CID book [65]
to scroll up through lists and menu options; to
increase the earpiece/speaker volume during a call;
to open the CID book
down/phonebook [66]
to scroll down through lists and menu options; to
reduce the earpiece/speaker volume during a call; to
open the phonebook
INT [67]
to set up an internal call to another handset; to
transfer an incoming call to another handset; to s
a conference call with an external line and an internal
handset
Redial [68]
to enter the redial book; to insert a pause when pre-
dialing a number
Star [48]
to turn on/off the keypad lock function; to set up a conference
call
Hash key [45]
to activate the door release
0-9 n umbers 0-9 / letters from A-Z / symbols
key assignment:
Key

Characters in the displayed order

0 (spc)
1 -
2 A
3 D
4 G
5 J
6 M
7 P
8 T
9 W
et up
& / .
1 @ _
B C 2
E F 3
H I 4
K L 5
N O 6
Q R S 7
U V 8
X Y Z 9
16.2 Icons on the LCD display (see fig. B)
New call
indicates that you have missed one or more calls
Picked up receiver
indicates that the line is engaged
Hands-free
indicates that the hands-free function is enabled
Battery icon
indicates the battery charge level (three black bars =
batteries are fully charged, one black bar = very low
battery power)
Signal icon
indicates the radio communication with the base; if the
handset is too far from the base, the icon will blink
Keypad lock
appears when the keypad is locked

17. Basic functions

All descriptions in this manual assume that the handset is in standby mode.
Set the telephone to standby mode by pressing the

17.1 Making a call

!
Pick up the handset and press the
the LCD, the handset is not in standby mode any more.
!
Dial a telephone number (max. 32 digits).
!
To end the call, either press the
base.
You can also enter the desired phone number in standby mode which allows
you to make corrections before dialling. Follow these steps:
!
Pick up the handset.
!
Enter a telephone number (up to 32 digits). If required, press the
key to insert a pause. "P" appears on the LCD.
!
Check the telephone number. If you made a mistake while entering the
number, you can use the
C/
!
When the number appears correctly, press the
will dial the number.
!
To end the call, either press the
base.

17.2 Receiving a call

When a new call is received, the call information will appear on the LCD and
the telephone rings.
key.
key. The icon appears on
key or replace the handset in the
key to clear the last digit.
key, and t he handset
key or replace the handset in the
GB - 45