cecotec ENERGYSILENCE AERO 5200 WHITEWOOD Bedienungsanleitung Seite 49

- Batteries 2 x AAA
- Instruction manual
3. ASSEMBLING THE APPLIANCE
1. Drill a ⌀8 mm hole in the ceiling and insert the bolt. Align the fixing bracket with the hole
and tighten it with the nut.
Fig. 2
A. Concrete ceiling
B. Wooden ceiling
2. Remove the clevis pin and clevis from the downrod. Pass the downrod through the
canopy and the decorative cover Fig. 3
3. Pass the electrical wires and the earth wire through the downrod. Fig. 4
4. Loosen the two fixing screws of the downrod bracket. Next, place the downrod in the
bracket. Align the holes in the downrod clevis pin with the holes in the downrod bracket.
Fig. 5
NOTE: be sure to insert the straight end of the clevis through the hole near the end of the
clevis pin until the curved part of the clevis fits into the clevis pin.
5. Finally, retighten the two fixing screws. Once the downrod is installed, cover the joint
properly with the decorative cover. Fig. 6.
WARNING
It is essential that the downrod bracket clevis screw is correctly installed and that the fixing
screws are tightened securely. Failure to check that the clevis screw, clevis clip and fixing
screws are correctly installed may cause the fan to fall.
Installing the blades
1. Unscrew the fixed screws and store them in a safe place. Fig. 7
2. Attach the blades to the fan body using the screws provided, making sure to tighten them
correctly. Fig. 8
3. Place the decorative cover in the installation hole to give a finishing touch to the
appearance of the ceiling fan. Fig. 9
With these simple steps, the installation of the fan blades will be effectively completed.
Hanging the fan
1. Lift the fan carefully and place the downrod and hanging ball assembly in the mounting
bracket attached to the ceiling. Fig. 10
ENERGYSILENCE AERO 5200 WHITEWOOD/ BLACKWOOD
ENGLISH
49