LED star (1033-S) with ground spikes
Attach the individual ground spikes
the LED star
and fix in place by
1
fastening the screws
hand (see Fig. B).
NB: Ensure the ground spikes are facing the
right direction (angle of the openings) as
shown in Fig. B.
Insert the product into the surface, e.g.
lawn/soil etc.
NB: Make sure the product is firmly
attached. Do not use force, e.g. a hammer,
during assembly or installation. This could
damage the product.
Setting up the LED tree (1033-T) with
stand
RISK OF DAMAGE! Before setting
up the product on the pedestal,
protect sensitive surfaces.
Using the two screws
underneath the LED tree
12
E).
Place the product on a flat surface. Make
sure that the stand is stable.
Setting up the LED tree (1033-T) with
ground spike
Using the two screws
spike
underneath the LED tree
14
Fig. F).
Insert the product into the surface, e.g.
lawn/soil etc.
NB: Make sure the product is firmly
attached. Do not use force, e.g. a hammer,
during assembly or installation. This could
damage the product.
48
GB/IE/NI/CY/MT
to
4
on the spike by
3
, fasten the stand
13
(see Fig.
11
, fasten the ground
13
(see
11
Connect power supply
RISK OF ELECTRIC SHOCK!
Plug the connector
the mains plug
8
Tighten the union cap
thread of the connection socket
Plug the mains plug
has been correctly installed.
NB: When using outdoors, plug the mains
plug
in to an IPX4 socket to ensure splash
8
protection.
z Operation
NB: Only use the product with the supplied
mains plug. Do not connect the product or
the mains plug to any external devices.
NB: The product stays lit as long as it is
connected to the power supply. If you plug it
out, the product is automatically switched off.
Timer function
To activate the timer function, keep the
button
on the mains plug
10
D) pressed down until the LED light turns
green. The timer has now been activated.
When the timer function is switched on, the
product is switched on for 6 hours and then
switched off for 18 hours.
Replacing the LEDs
RISK OF ELECTRIC SHOCK!
Incorrect handling of the product or
incorrect installation may potentially
result in personal injury.
The light source contained in this product
shall only be replaced by the manufacturer
or his service agent or a similar qualified
person.
Do not replace the light source while the
product is connected to the mains.
into the socket
5
7
(see Fig. C).
on the screw
6
�
7
into a socket that
8
(see Fig.
8
of