DIEBOLD HS 1100-P Bedienungsanleitung Seite 45

Horizontal-Schrumpfgerät
Horizontal Shrinking Device
HS 1100-P
19.5. Shrinking without Parameters with indicating the power level
1. Turn on the unit with the main switch
2. Press the "Menü" button until "Manuell" is shown in the display
3. Select the Power level with the "+" or "–" button
 Power level:
 30%
 40%
 50%
 75%
 100%
4. Insert the correct ferrite interchangeable disc
 Disc selection:
 Ø3-5
 Ø6-12
 Ø14-22
 Ø25-32
5. Set the induction coil in the position over the heat shrink tool so that the shrink
chuck is in contact with the ferrite interchangeable disc
6. Press and hold the "Start/Stop" button until shrink or un-shrinking the tool
BA_79-329_0_D+E.docx
Full power (100%):
When shrinking HSS tools, full power must be applied, otherwise
releasing of the tool will not work. Most carbide tools may also be
heated at full power.
Reduced power (30% - 75%):
When shrinking carbide tools in holders with thin nose type or slim
chucks (especially shrink extensions), it is recommended to heat
with reduced power to avoid overheating of the shrink chuck
Shrink chucks with D1<17 mm should always be heated with
reduced power
If it is not possible to shrink a carbide tool using reduced power,
then the shrink process with full power may be used
Copyright © Diebold 2016-12 Ersteller: kh Seite 45 von 60