XS Instruments 50 Serie Betriebsanleitung Seite 11

Installation
• Supplied components
The instrument is always supplied with all the accessories necessary for being put into service; the
version without sensor is always supplied with:
instrument complete with multi-socket adapter, 1m S7/BNC connection cable, NT55 temperature
probe, buffer solutions in single-dose bottle and / or sachet, electrode holder stand, multilingual user
manual and test report.
There are versions with the sensor(s) already included. Contact your local distributor to be updated on the
correct composition of the sales kit.
• Start-up
•
Place the instrument on a flat, stable laboratory table with appropriate front and side accessibility. It is
recommended to place the instrument at not less than 20 cm from overlying and surrounding parts.
•
Positioning the device in this way, there is no more residual risk of possible minor damage caused by
manual handling of loads.
•
Make sure that the instrument and the surrounding environment are correctly illuminated.
• Connection of the power supply
•
Check that the electrical standards of the line on which the instrumentation is to be installed comply
with the voltage and operating frequency of the instrument.
•
Use the original power supply only.
•
Connect the power supply plug to the connector on the rear panel of the instrument indicated with
the icon .
•
Connect the power supply to an electric socket easy to reach.
•
The instrument is equipped with a power supply unit which is not protected against any liquid entry;
therefore, for its use, it is necessary to keep all electrical cables and connections away from any liquids,
humidity and not to use the device in a humid room, such as a bathroom or a laundry room.
ATTENTION
Danger of death or serious injury from electric shock.
Contact with live components can lead to injury or death.
•
Use the adapter supplied only.
•
Do not put the power supply in contact with liquids nor in a condensing environment. Avoid thermal shock.
•
All electrical cables and connections must be kept away from moisture or liquids.
•
Check that the cables and plugs are not damaged, otherwise replace them.
•
During use, do not cover the power supply and/or do not place it inside containers.
•
In the event of accidental loss of power during the operation of the instrument, there is no dangerous
condition for the user.
•
The instrument is NOT automatically reactivated. Press the button
• Turning On and Off
Turn on the system by pressing the button
appears:
•
model and firmware of the instrument;
•
settings relating to the most important parameters and possible information about the DHS sensor;
UM Serie 50VioLab EN rev.2 26.07.2021
. The display initially activates all segments and then
10
to turn the device back on.
EN