Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.5
Grinding angles
Set the upper part of the support by means of the scale (38) and the vernier (39). Both values
must be set to 0.
Release the clamping lever (42) and then tilt the slewing arm (40) at an angle of 0 degree.
Then, release the clamping lever (18) in order to be able to move the shaft.
Set the slewing arm (40) to the desired angle by releasing the lever (44). Turn the handwheel
(12) in order to set the stop.
40
12
Operation
Version 1.0.7 dated 2018-11-20
37
39
42
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
38
44
18
GH 20T
®
GB
Page 59
Werbung
