Maintenance And Cleaning; Technical Data - VOLTCRAFT BS-16 Bedienungsanleitung

c) main menu bar
file
Set Capture File...
Allocate File Space...
Save Captured Video...
Exit
Devices
Telescope Driver
Options
Preview
Video Capture Filter...
Video Capture Pin
capture Start Capture
Stop Capture
Set Frame Rate...
Set Time Limit...
Below the main image, the number of pictures captured is displayed in the status bar.
The driver included in delivery is "TWAIN32-compatible". The camera can thus be operated with
any program that supports this interface.
d) Image settings
Stream Property Image Control:
■ Image mirror (mirror image), ■ Image flip (flip image around), ■ Brightness
(Confirm settings with
(set brightness), ■ Contrast (set contrast), ■ Gamma (set contrast colour),
"OK", cancel with
■ Hue (set hue), ■ Sharpness (set sharpness), ■ VGA snap size (set image
"Cancel")
size, leave setting on 640 x 480), ■ Zoom (set zoom in %)
Auto Mode Control (auto setting):
Leave ticked settings to achieve best possible image quality.
Default (basic settings):
■ Reset (reset settings), ■ Save (save settings), ■ Restore (restore basic
settings)
In/Out Door (indoor/outdoor area):
■ Indoor (indoor area), ■ Outdoor (outdoor area),
Flickr (flicker rate):
Set flicker rate
Extra Control (extras):
■ Backlight compensation (backlight), ■ B/W Mode (black/white mode)
Effect frame Effect (effects):
■ Disable , ■ Invert, ■ Black/White, ■ Green Mono, ■ Gray Scale, ■ Blue
(Confirm settings with
Mono, ■ Red Mono, ■ Emboss, ■ Find Edge, ■ Mosaic, ■ Wind, ■ Solarize,
"OK", cancel with
■ Sepia, ■ Bathroom, ■ Sketch, ■ Oil Paint, ■ DistortH, ■ DistortV, ■ Monitor
"Cancel")
Frame:
■ Disable, ■ Flowers, ■ Paper, ■ Snipe (Sniper), ■ Snowman
Select storage location for video recordings (avi).
The file must have the extension ".avi". You will
be prompted to enter the file size.
Set storage size, and the available size will be
displayed. In the "Capture File Size" menu item
the size in megabyte (MB) can be entered.
Store a recorded video sequence.
Exit program.
Select the menu item "Telescope Driver" for this
product.
Turn image display on and off
see "d) Image settings"
Video format:
■ Video standard (not changeable), ■ Frame
rate (set frame rate, do not alter 30 frames/sec),
■ Colour space / Compression (preset to RGB
24, do not alter), ■ Output size (preset to 640 x
480, do not alter)
Compression:
not changeable
Confirm settings with "Apply" and then "OK".
Starts a video recording. Confirm with "OK",
cancel with "Cancel".
End recording.
Set frame rate for the recording (frames/sec).
Leave the setting at 30 frames/sec. Confirm with
"OK", cancel with "Cancel".
Input a maximum recording length in seconds.
We recommend that this setting not be changed.
Confirm with "OK", cancel with "Cancel".
e) Snapshot
To make snapshots press the snapshot button SNAP (6). A further window with the snapshot picture will
open:
file(f) Save image in ".jpg" format (Save)
Exit (Exit)
Rotate Orientation Rotate image in selected angular degree.
help(h) Show information about program
The snapshot function can only be carried out with administrator rights. Contact your system
administrator for this.
f) Attachments
Carefully open the mounting ring of the attachments (1) for installation and attach it at the thin recess below the
camera head. When opening, do not excessively bend the accessories (risk of breakage).
• The magnet attachment helps locate lost metal objects.
• The mirror attachment can extend the field of vision into areas that would otherwise be hardly accessible
to the camera head.
• The hook attachment allows grasping small objects.

mAINTENANcE AND cLEANING

Do not submerge the main product in water!
The product requires no servicing aside from occasional cleaning. Use a soft, anti-static and lint-free cloth
for cleaning.
Thoroughly rinse the endoscope's gooseneck after each use in liquids, using clean water and drying it
before storing it in the case.
DISPOSAL
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
You thus fulfil your statutory obligations and contribute to the protection of the environment.

TEchNIcAL DATA

Operating voltage ....................................5 V/DC via USB, 200 mA
USB interface ..........................................min. USB1.1
Camera sensor ........................................CMOS 1/6"
Camera resolution ...................................640 x 480 pixel (VGA)
Frame rate ...............................................30 fps
White balance ..........................................automatic
Exposure .................................................automatic
Video format ............................................AVI
Camera lighting .......................................4 LEDs, white
Operating conditions ................................0 to +45 °C, 15 – 85 % RH
Storage conditions ...................................-10 to 50 °C, 15 – 85 % RH
Bend radius .............................................> 60 mm
Camera head Ø .......................................11.5 mm
Field of vision ...........................................54°
Focus .......................................................>60 mm
Gooseneck length ....................................approx. 96 cm
Cable length ............................................approx. 200 cm
Operating systems ...................................Windows
Dimensions (L) ........................................approx. 115 cm (without cable)
Weight .....................................................approx. 415 g
Legal notice
These operating instructions are a publication by Voltcraft
®
(www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© copyright 2013 by Voltcraft
®
98, ME, 2000, XP, Vista™, 7, 8
®
, Lindenweg 15, D-92242 Hirschau/Germany, Phone +49 180/586 582 7