Korg Kaossilator Pro Bedienungsanleitung Seite 15

"PrNo.": Only the program will be loaded.
"ALL.P": All stored settings (program, scale,
key, note range) will be loaded.
CrCt: Turns the Touch Pad Correction function
on/off.
SYNC: Specifies whether loop recorder opera-
tions will synchronize to BPM.
If this is on, the recorder will synchronize to
BPM, but the sound may be interrupted at the
beginning of the phrase. If this is off, the re-
corder will not synchronize to BPM, but there
will be no interruption of the sound. However if
you change the length of the phrase or if you
change the BPM, the recorder will automati-
cally operate as if SYNC were on.
TIP: When operating with BPM SYNC off, the TAP
TEMPO button will blink green. When operating with
BPM SYNC on, the TAP TEMPO button will blink
red.
In order to operate with SYNC turned off, you must ei-
ther start just after turning on the KAOSSILATOR PRO, or
initialize all banks, and then match the length of the phras-
es before you record. Even if SYNC turns on automatically,
there has been no change to the SYNC setting, so turning
the power off and on again will make the KAOSSILATOR
PRO operate with this setting off.
[7] USB
You can connect the KAOSSILATOR PRO to
your computer and read/write the contents of
the inserted card via USB (→p.18: Accessing
the SD card from your computer).
[8] EXT.CTRL
This lets you use the KAOSSILATOR PRO as
a MIDI controller.
The MIDI message assigned to each control-
ler using the KAOSSILATOR PRO Editor will
be transmitted (→p.22: Using the KAOSSILA-
TOR PRO as a MIDI controller).
TIP: You can download the KAOSSILATOR PRO Edi-
tor from the Korg website. (http://www.korg.com)
15