Operation - Hilti DX 35 Bedienungsanleitung

Minimum distances and spacing when fastening to concrete
7.1.2 Depth of penetration
NOTE
Examples and specific information can be found in the Hilti Fastening Technology Manual.
Nail lengths for steel
ET
Nail lengths for concrete
ET

8 Operation

WARNING
The material may splinter or fragments of the magazine
strip may fly off when the fastener is driven. The user of
the tool and other persons in the immediate vicinity
must wear protective glasses and a hard hat. Splin-
tering material presents a risk of injury to the eyes and
body.
CAUTION
The fastener driving action is initiated by ignition of a pro-
pellant charge. The user of the tool and other persons
in the immediate vicinity must wear ear protectors.
Exposure to noise can cause hearing loss.
WARNING
Never make the tool ready to fire by pressing it against a
part of the body (e.g. the hand). This could cause a nail
A min. edge distance = 70 mm (2³⁄₄")
b min. spacing = 80 mm (3¹⁄₈")
c min. base material thickness = 100 mm (4")
ET Depth of penetration: 12 ± 2 mm (½" ± ¹⁄₁₆")
ET Depth of penetration: 22 mm (max. 27 mm) (⁷⁄₈"
(max. 1"))
or the piston to be driven into a part of the body. Never
press the tool against a part of the body.
WARNING
Never redrive a fastener. This may cause the fastener
to break and the tool may jam.
WARNING
Never drive fasteners into existing holes unless this
is recommended by Hilti (e.g. DX‑Kwik).
CAUTION
If the tool has overheated, allow it to cool down. Do
not exceed the recommended fastener driving rate.
8.1 Procedure if a cartridge fails to fire
If a cartridge fails to fire or misfires, always proceed as
follows:
Keep the nose of the tool pressed at right angles against
the working surface for 30 seconds.
en
23