Herunterladen Diese Seite drucken

Zanussi ZTA 250 Benutzerinformation Seite 12

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

exterior wall or ceiling, it must be ensured an ex-
haust capacity of at least 150 m3/h. If the dryer
is fitted next to kitchen units, make sure that the
vent hose is not squashed. If the hose is partial-
ly squashed, drying efficiency will be reduced,
resulting in longer drying times and higher ener-
gy consumption. If the hose is completely
squashed, the safety cut-outs with which the
machine is fitted may operate. When operating
the tumble dryer, the room temperature must
not be lower than +5°C and higher than +35°C,
as it may affect the performance of the appli-
ance.
Electrical connection
Details on mains voltage, type of current and the
fuses required should be taken from the type
plate. The type plate is fitted near the loading
aperture (see "Product description" chapter).
Connect the machine to an earthed sock-
et, in accordance with current wiring regu-
lations.
Warning! The manufacturer declines
any responsibility for damage or
injury through failure to comply with the
above safety precautions.
Should the appliance power supply cable
need to be replaced, this must be carried
out by our Service Centre
Environment
The symbol
on the product or on its
packaging indicates that this product may not
be treated as household waste. Instead it
should be taken to the appropriate collection
point for the recycling of electrical and
electronic equipment. By ensuring this product
is disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product,
please contact your local council, your
household waste disposal service or the shop
where you purchased the product.
12
Warning! Make sure not to cause
damage to the mains plug and to the
mains cable.
Connect the mains plug to the mains
socket only at the end of the installation.
Make sure that there is access to the
mains plug after the installation.
Door reversal
To make it easier to load or unload the laundry,
the door can be reversed. The door must only
be reversed by an authorised service engineer.
Please contact your local Service Force Centre.
The engineer will carry out the door reversal at
your cost.
Special accessories
Stacking kit
A special stacking kit is
available through your
dealer, to enable the
mounting of the dyer on
top of a front loading
washing machine with
cover's depth between
48 and 60 cm. Read
carefully the instruc-
tions supplied with the kit.
Packaging material
The packaging materials are environmentally
friendly and can be recycled. The plastic com-
ponents are identified by markings, e.g. >PE<,
>PS<, etc. Please dispose of the packaging
materials in the appropriate container at the
community waste disposal facilities.
Warning! When disposing of old
appliances, remove the mains cable and
dispose of together with the plug. Remove the
door hook and ensure it is no longer lockable to
prevent young children being trapped inside.
Environmental tips
• In the dryer, laundry becomes fluffy and soft.
Fabric softeners are not therefore needed
when washing.
www.zanussi.com

Werbung

loading