Height Of Cut - Jacobsen G-Plex III Betriebs- Und Sicherheitshandbuch

9 ADJUSTMENTS
GB
9.4

HEIGHT OF CUT

NOTE: All three cutting heads MUST be
accurately set at the same height of cut to
insure an even cut.
Bedknife adjustment must be made before
setting the height of cut.
A gauge block (Part No. 892010) is offered
separately. Order from an authorized
Textron dealer.
1. Set the height of cut on the gauge block
(Part No. 892010) by turning the wingnut
until the distance between the bottom of
the screw head and the top of the gauge
block equals the desired height of cut (See
Fig. 9.4.2).
2. Loosen the locking nut on one of the front
roller adjusting brackets just enough to
allow adjustment (See Fig. 9.4.1).
3. Hold the gauge block (Part No. 892010)
across the bottom of both the front and
rear rollers near the roller adjustment
bracket and adjust the front roller until the
cutting edge of the bedknife comes up to
touch the bottom of the gauge screw head
(See Fig. 9.4.2).
4. Tighten the locking nut and repeat the
procedure at the other end. After
adjustment has been made at both ends,
go back and recheck both ends.
5. Make sure all three cutting heads are set
without changing the height of the gauge
screw.
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL
Figure 9.4.1
1. Loosen Locking Nut
Figure 9.4.2
Height of Cut Adjustment
A = Rear Roll
B = Front Roll
C = Gauge Screw Head
D = Bedknife
E = Height of Cut
GB-23