As-Delivered State Of The Operating Data; Operating Data According To Ex-Factory Basic Setting (Standard Device); Factory Set Customer-Specific Operating Data - Siemens SITRANS TW 7NG3242 Betriebsanleitung

Installation and commissioning
The transmitter is in operation after approx. 5 seconds when the power supply is
switched on.
WARNING
– The following applies for devices with "intrinsically safe" type of protection:
Only intrinsically safe circuits can be connected to the transmitter input.
– The "intrinsically safe" protection type is no longer effective in the case of
improper feeding (see also warnings on page 126).
6.6

As-delivered state of the operating data

The basic operating data and the specifications for hardware options are on a
permanently attached hardware rating plate (7a, figure 2, page 83) under the
replaceable software rating plate (7, figure 2, page 83).
The as-delivered state of the rating plate with the software operating data (7, figure 2,
page 83) depends on whether standard devices or customized devices are ordered.
The transmitter is delivered as follows depending on the order:
6.6.1 Operating data according to ex-factory basic setting
(standard device)
Operating data deviating from the presetting must be adapted to the respective
measuring job by the customer before commissioning the transmitter.
A replaceable blank rating plate (7, figure 2, page 83) is used for manual entry of the
entered operating data or can be replaced by one the user has printed.
6.6.2

Factory set customer-specific operating data

The device is ready for operation for the respective measuring job after installation
and electrical connection The set operating data are documented on the software
ratingplate (7, figure 2, page 83).
132
SITRANS TW
A5E00054075-05