Werbung
Verfügbare Sprachen
Verfügbare Sprachen
@ Fast forward/rewind button/LED
indicator [ <q / >> ]
Fast forward
Depress the 44 button to Fast forward when the q on
the program indicator® is lit. The }»P button is to be
depressed to Fast forward when the P is lit.
e@Rewind
Depress the >
button to rewind when the q on the
program indicator® is lit. The 44
button is to be
depressed to rewind when the P is lit.
When the tape reaches its end in the fast forward or
rewind mode, the tape reverses automatically and play
back is started.
@ Program changeover button/program
'
indicator [program]
When this button is depressed during playback, the tape
program changes from A side to B side or from B side toA
side with simultaneous
changeover
of the program
indicator.
@ TPS button/TPS indicator [TPS]
[Tape Program Sensor]
This button is to be depressed during playback mode
followed by F.F. or REW:
Rewind:
Tape will rewind to the beginning of the
song
being
played
and
resume
playback.
Fast forward:
Tape will fast forward to the beginning of
-
the next song and resume playback.
®Tape slot
The cassette tape is inserted into this slot.
Be sure to insert the cassette tape with the open section
(the side where tape is visible) on the left.
@ Tape changeover button/LED indicator
[tape]
This button is set as follows according to the tape to be
used.
CrOz/metal (.=): When a CrOz type tape or a metal tape
is used. (LED comes on.)
normal (8):
When an ordinary tape is used.
@ Dolby NR changeover button/LED
indicator [Dolby NR]
in (m):
Whena
tape recorded in Dolby mode is played
back. (LED comes on.)
Noise is reduced and the sound played back is
free of loud tape hiss.
out (1): When the tape played back is not recorded in
Dolby mode.
@ Antenna lead
Connect to the car antenna.
@ Inter connection harness
Connect to the Input connectors of the power amplifier.
. & Power wire for back up/deck
Connect to the power extension wire.
© Power extension wire
Connect to the (+) terminal on the car's battery or to the
terminal on the fuse block marked as battery.
® Speaker harness
Connect to optional speaker systems. (See page 18).
@ Ground wire
Connect to a grounded, metallic part of the car.
-© Main power wire
Connect to the power extension wire (included).
Then connect it to the (+) terminal on the car's battery or
to the fuse box section
marked
''battery'' which
is
connected with a wire of 412 (AWG) or larger.
© Radio power wire
Connect to the "ACC" terminal of the car's fuse block.
@ Input connectors
Connect to the Inter connection harness®.
Power amplifier protection circuit
The power amplifier contains a protection circuit to
safeguard the unit from damage.
It cuts off the main amplifier's circuits automatically,
when the speaker leads or terminals are shorted. (The
FM/AM tuner, cassette deck and preamplifier continue
to function normally.)
If there is no sound even when the Volume control
button@
(up)
is depressed
and
the
LED
level
indicator@® lights up, this circuit may
have been
actuated. Switch the power off and check the speaker
connections before switching the power on again.
Werbung
