Assembly - Tunturi Platinum Cross Sprinter Gebrauchsanweisung

Assembly

Start by unpacking the equipment. The detailed assembly
instructions can be found at the back of this guide. Follow
the instructions in given order.
Before assembly, check the contents of the package. If
a part is missing, please contact your dealer with the
model, equipment serial no. and spare part no. of the
missing part. You'll find a spare part list at the back of this
guide. The hardware kit contents are marked with * in the
spare parts list. The directions left, right, front and back
are defined as seen from the exercising position. Keep the
assembly tools, as you may need them e.g. for adjusting
the equipment. Note that two people are needed for the
assembly.
The packaging includes a silicate bag for absorbing
moisture during storage and transportation. Please dis-
pose of the bag once you have unpacked the equipment.
Allow at least 100 cm of clearance around the equip-
ment. We also recommend opening the package and
assembling the product on a protective base.
1.
English
4
Step 1: Upright tube
1. The tension adjustment cable and speed sensor wire
are pre-installed to the upright tube and main frame
so be careful not to pull too hard on the upright tube-
during assembly to avoid damaging them. Connect
the two speed sensor wires together.
2. Lift the upright tube (2) into place and align it so that
the locating pins in the mounting plate are set into
the holes in the mating plate of the main frame. Be
careful not to pinch the speed sensor wire between
the upright tube and the main frame plates during
assembly.
3. Secure the upright tube in place with the four M10
x 20mm stainless steel bolts (49) and M10 split
washers (56). Make sure the bolts are securely tigh-
tened.
4. Install the fixed handlebars (3) to the upright tube with
four M10 x 25mm stainless steel bolts (50) and M10
split washers (56). Make sure the bolts are securely
tightened.