Important Assembly Information; Assembly; Fasten Nuts And Bolts; Care And Maintenance - Tunturi PT 40 Power Tower Benutzerhandbuch

English
- Do not place any sharp object around
the equipment.
- Disabled person should not use the equipment.
- Before using the equipment to exercise, always
do stretching exercises to properly warm up.
- Never operate the equipment if the equipment
is not functioning properly.
- A spotter is recommended during exercise.
- This equipment is designed and intended
for home and consumer use only, not for
commercial use.
Warning:
Before beginning any exercise program,
consult your physician. This is especially
important for individuals over the age of 35
or persons with pre-existing health problems.
Read all instructions before using any
fitness equipment.
Tunturi New fitness bv. assumes no
responsibility for personal injury or property
damage sustained by or through the use of
this product.
Save these instructions!
Important assembly
information
Tools Required for Assembling the Bench:
Two Adjustable Wrenches.
‼ NOTE
• It is strongly recommended that this
equipment is assembled by two or more
people to avoid possible injury.
- Ensure Carriage Bolts are inserted through the
SQUARE holes on components that need to be
assembled. Attach washer only to end of the
Carriage Bolt.
- Use Allen Bolts or Hex Bolts inserted through
the ROUND hole on components that need to
be assembled.
- Always wait until all bolts are assembled onto
the bench before tightening the bolts. Do not
tighten each bolt right after it is installed
10

Assembly

(Fig. A)
⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around
the equipment.
• Refer to the illustrations for the correct
assembly of the equipment.

Fasten Nuts and Bolts

‼ NOTE
• Do not over tighten any component with
pivoting function.
• Make sure all pivoting components are able
to move freely.

Care and maintenance

- Lubricate moving parts with WD-40 or light
oil periodically.
- Inspect and tighten all parts before using
the equipment.
- The equipment can be cleaned using a damp
cloth and mild non-abrasive detergent. DO
NOT use solvents.
- Examine the equipment regularly for signs
of damages or wear.
Securely tighten all
Nuts and Bolts after
all components
have been assembled
in current and
previous steps.
Do not tighten all
Nuts and Bolts in
this step.