Philips HR2345/19 Benutzerhandbuch Seite 8

ENGLISH
10
y Thoroughly clean all parts before you use the appliance for the first time (see
chapter 'Cleaning').
1 Pull the lid to unlock it and then remove the lid from the mixing chamber. (Fig. 3)
2 Slide the mixing chamber off the main unit.
3 Turn the shaping disc holder counterclockwise to remove it from the mixing chamber
outlet. (Fig. 5)
4
Put your finger in the mixing chamber and push the squeezing tube outwards to slide
it out of the mixing chamber outlet (Fig. 6). Detach the shaping disc, and then pull the
squeezing bar out of the squeezing tube (Fig. 7).
5
Take the mixing paddle out of the mixing chamber. (Fig. 8)
6 Clean all detachable parts and accessories, and then wipe them dry. (Fig. 9&10)
Assembling
Important
y Make sure the appliance is not plugged in during assembly.
1 Slide the mixing chamber onto the main unit. (Fig. 11)
Note: Make sure the fixing levers
the bottom of the mixing chamber.
2
Put the mixing paddle in the mixing chamber. (Fig. 12)
3 Insert the squeezing tube into the mixing chamber. (Fig. 13)
Note: Make sure the big opening on the squeezing tube faces up when you insert the
tube into the chamber.
4 Insert the squeezing bar into the mixing chamber. Make sure the squeezing bar slides
all the way through both the squeezing tube and the mixing paddle and into the
shaft in the main unit. (Fig. 14)
Note: Slightly turn the mixing paddle to make sure the squeezing bar is connected
correctly with the shaft
5 Attach the shaping disc on the mixing chamber outlet. (Fig. 15)
Note
y Make sure the flat side of the shaping disc is facing out.
y Make sure the shaping disc fits into the fixing point on the squeezing bar.
y Make sure the arrow on the shaping disc face upwards when you attach it on the
mixing chamber outlet. Pay special attention when you do so for the lasagna/
dumpling shaping disc. This is to make sure that the opening of the lasagna sheet
is on the top.
6 Press the shaping disc through the opening of the shaping disc holder (Fig. 16), and
then assemble the holder on the mixing chamber outlet. Turn the holder clockwise to
firmly lock it in place (Fig. 17).
Note: Always attach the shaping disc on the mixing chamber outlet before you
assemble the shaping disc holder. Never put the shaping disc in the shaping disc
holder and assemble them on the mixing chamber outlet at the same time. (Fig. 18)
(Fig. 4)
on the main unit are fitted with the openings on
in the main unit.