Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SAFETY FUNCTIONS AND ERROR DISPLAY
The cooking hob is fitted with overheating sensors. These sensors can automatically
switch off any cooking zone or the entire hob temporarily.
Error, possible cause, solution
• Continuous beep and »–« fl ashing on the display.
- Water spilt over sensor surface, or an object placed over the sensors. Wipe the sensor
surface.
• »C« on the display
- Cooking zone has overheated. Wait for the cooking zone to cool down.
• »r« on the display
- This indicates that the desired power level cannot be set because the limit for
maximum total cooking hob power has been activated.
• »F« on the display
- This indicates that there has has been an error during operation.
If the problems persist despite observing the advice above, call an authorized service
technician. Repair or any warranty claim resulting from incorrect connection or use of the
appliance shall not be covered by the warranty. In this case, the user will cover the cost of
repair.
24
If an error occurs or if the error indicator "F" does not disappear,
disconnect the cooking hob from the power mains for a few
minutes (undo the fuse or switch off the main switch); then,
reconnect the hob to the power mains and switch on the main
switch key.
Before the repair, disconnect the appliance from the power mains
(by removing the fuse or by removing the plug from the wall
outlet).
Werbung
