Product Specifications; Safety Instructions - Solo 421 Originalbetriebsanleitung Und Gebrauchsanweisung

Caution: Before using this product, read this
manual and follow all Safety Rules and Operating
Instructions.
Dear Customer,
The SOLO model 421 portable spreader is
designed for spreading a variety of materials over
irregular terrain more conveniently than a wheeled
spreader. A few of the possible uses include
spreading:
• Ice melters, • Oil absorbers, • Seed, • Bird seed,
• Sand, Salt, etc. • Cleaning agents, • Fertilizers,
• Feed stock, • Pelletized lime, • Wild game feed
The model 421 spreader requires very little
maintenance and will provide good service with
regular cleaning and periodic lubrication of the
gearbox.
PRODUCTSPECIFICATIONS
Weight: 5.5 pounds (2,5 kg) (empty)
Capacity: 20 lbs. (as of 9 kg)
Height: 19 in. (50 cm)
Width: 11 in. (28 cm) without handle
Carry Strap: Included
Flow Rate: Adjustable
Directions: 180° adjustable
Gears: Metal worm gear drive
Agitator: Built-in agitator turns steadily
during cranking

SAFETY INSTRUCTIONS

TRAINING
Read the owner's manual carefully. Become
familiar with the controls and know how to operate
your spreader.
 Do not allow children to use your spreader.
Never allow adults to use the spreader without
proper instructions.

Do not bend at the waist. Bend only at the knees
and support yourself as required to ensure
personal safety.
 Keep the treatment area clear of people and
pets, especially small children.

Use spreader only as described in this manual.
 Do not operate spreader if it has been dropped
or damaged in any manner. Always have
damage repaired before use.
 Do not use accessory attachments that are not
recommended by the manufacturer. Use of such
attachments may be hazardous.
PREPARATION AND SAFETY
 Always wear safety glasses or eye shields when
using your spreader.

Dress properly. Wear only closed toed shoes
with good traction.
 Do not operate spreader when barefoot or
wearing open sandals.
- ENGLISH –

Wear long-sleeved clothes that are snug fitting.
Avoid wearing loose clothing.
 Wear either tightly cuffed or cuffless pants.
 Wear non-slip gloves during operation. Wear a
respirator if appropriate for the type of material
being spread.
 Long hair should be tied back and kept away
from the spreader.
 Make directional adjustments before using the
spreader.

Use only in daylight or good artificial light.
 Read all instructions of the chemical
manufacturer.
CAUTION
 Keep your eyes and mind on the job at hand. Do
not become distracted.
 Always be sure of your footing. Use extra caution
in wet or slippery areas. WALK - DON'T RUN.
WARNING: Chemicals or materials which can be
harmful to individuals or the environment should
be avoided. Follow all warnings of the chemical
manufacturer.
MAINTENANCE AND STORAGE
 Check all bolts, nuts, and screws at frequent
intervals for proper tightness to be sure the
spreader is in safe working condition.
 Keep all safety devices in place and working.
CUSTOMER RESPONSIBILITIES

Read and observe the Safety Rules.
 Follow a regular schedule in maintaining, caring
and using your spreader.
 Follow the instructions under the Maintenance
and Storage sections of this manual.
Your SOLO 421 spreader needs to have the carry
strap and the crankhandle attached before
operation.
Remove the hopper lid. The crank handle and
carry strap are located inside.
Mounting the Crank Handle
 Place the spreader on it's left side (as viewed
from the operators position). Figure A.
 Find the threaded crankshaft and affix the crank
handle in a clockwise motion, tighten the jamnut
against the crank handle.
Carry Strap
 Stand the spreader upright at about waist level
on a table, bench or stand.

Adjust the strap to ist longest reach.
 Attach the strap hook to the top right eye on the
hopper (as viewed from operator's position).
 With the back of the spreader facing your chest,
slip the strap over your right shoulder and across
your back.
 Set strap hook under spreader housing.
See Figure B.
ASSEMBLY