Brita Tap WD 3010 Gebrauchsanleitung Seite 8

First of all, dismount your existing kitchen tap.
A a) Turn off the cold and hot water supplies
b) P lease make sure you release any pressure by opening
all levers.
!
No water should run through the existing kitchen tap!
c) U nscrew the existing hoses from the cold and hot water
s upply.
We recommend placing a suitable container under the water
!
supply as there will be water left in the hoses which will run
down when you unscrew them!
d) U nscrew your kitchen tap – there is no standard mounting but
in general a pipe wrench will help you to dismount it.
e) Pull out both your kitchen tap and the hoses.
You're now ready to install the B RITA Tap
(see fig. 5).
First of all, screw the shank (2) into the BRITA Tap (1).
Screw the hoses into the dispenser (see fig.6).
Screw the M8 connector of the hose with the blue stripe into the
hole C .
Screw the M8 connector of the hose with the red stripe into the
hole H.
Screw the M8 connector of the 800 mm hose into the hole B.
WD 3020/ W D 3030/ W D 3040 and WD 3050
WD 3010
C H
B
(fig. 8)
!
Ensure the connections are screwed tight, but avoid over
tightening!
Then put the base (3) over the hole and fix the B RITA Tap (1) in
place using the supplied counter plate (4), the gasket (5), the lock-
ing ring (6) and the hexagon nut (7).
8
ENGLISH
C
B H
3.4 Step 4: Attaching the hoses
!
We recommend that you arrange all the parts you need in
front of you before you begin.
For wall mounting (optional), you will need: two screws (e.g. 5 mm
thread diameter) and, if required, two wall plugs suitable for your
type of wall.
Please follow the diagram below (see fig. 7) and perform the steps
in the right order.
a) Connect supplied T-piece on your cold water supply
a. Insert one 3/8" gasket into the female nut of the supplied
T-piece.
b. Connect this end of the t-piece to your cold water supply.
If you do have an additional free 3/8" cold water supply for
the B RITA Tap in your kitchen, you do not need to install the
supplied T-piece!
!
If your cold water supply does not fit the 3/8" connector
of the T-piece, use the supplied adapter if required. Please
insert the 1/2" gasket into the female nut of the adapter first.
Your Starter Kit comes with two 1/2" adapters. Please go to
your nearest supplier for adapters in other sizes.
b) Connect the hose with the blue stripe to one side of the T-piece.
c) Take the hose with two 3/8" connectors. Insert the 3/8" g askets
into the respective female threads of the two hose ends. Con-
nect one end with the free side of the T-Piece.
d) Now connect the other end to the filter head inlet. This is labelled
"IN" (inlet) and marked with an arrow. Make sure that the gas-
kets are seated correctly!
e) Connect the 800 mm hose which is connected with the
dispenser with the outlet of the filter head labelled with an out
arrow.
f) Connect the hose with the red stripe with your hot water supply.
If your hot water supply does not fit the 3/8" connector, use the
supplied adapter if required. Please insert the 1/2" gasket into
the female nut of the adapter first.
g) Make sure all connections are tightened properly. Avoid over
tightening.