LR-Cal XP100 Bedienungsanleitung Seite 32

XP100 und
MANUAL
XP100 and
b) If W >= 1
r
W = aH[W - 1] + bH[W - 1]² + cH[W - 1]³ + dH[W - W Al)]²
Default se ng:
aH = 0; cH = 0; dH = 0; W-Al = 3.3760086
„Measuring mode" screen
fig. A
40
41
42
43
44 45
fig. B
Tel. +49 (0) 7121-90920-0 • Fax +49 (0) 7121-90920-99 • DT-Info@Leitenberger.de •
LR-Cal LRT 1000
LR-Cal LRT 1000
(40)
Indicates the current temperature value.
(41)
Displays informa on on the current measuring mode and
the characteris c curve.
(42)
This symbol indicates, that the displayed measured values
under (43) are calculated (e.g. minimum/maximum
measured value).
(43)
Indicates the calculated measured values according to the
selec on (e.g. minimum/maximum measured value).
(44)
Sets the measured values displayed under (43) and the
dura on back to zero.
46 47
(45)
Specifies how the measured values under (43) are shown
(see fig. ):
Minimum:
Maximum:
Average:
Hold:
Off:
(46)
Carries out an automa c measurement for the dura on of
an already specified recording interval. The recording
interval can be specified in the following screen (see fig. C
and fig.
(47)
Saves the currently displayed measured values as single
measurement in the archieve with date and me stamp.
DRUCK & TEMPERATUR Leitenberger GmbH • Bahnhofstr. 33 • D-72138 Kirchentellinsfurt • GERMANY
B
Always shows the smallest detected
measured value from a measuring period.
Always shows the largest detected
measured value from a measuring period.
Shows the average value of all measured
values which have been detected so far
from a measuring period.
Pauses the current detected measured
value and shows it con nually (when this
op on is selected).
Switches the display (42) off.
D on the next page).
32
www.LR-Cal.net • www.druck-temperatur.de