LaserLiner ThermoXplorer Pro Bedienungsanleitung Seite 38

16.0
Activate / deactivate measurement points
Up to two measurement points can be set at one time. They can be assigned
measurement-specific parameters as well as the following properties: maximum
temperature, minimum temperature, manual positioning.
Measurement
Level/Span
Setup
File
!
All added measurement points, lines and areas are removed by selecting „None".
16.1 Measurement points / parameters
S1=19.3
Emissivity
Set emissivity for point 1 (S1).
Refer to Section 11.1.
A * symbol is shown
! next to the measured
value if values are de-
fined for measurement
points, lines or areas.
Set Ref
The temperature of point 1 (S1)
shows the reference temperature
(R). Refer to Section 10.2.
Delete point
The point is deleted.
38
GB
Measurement
Type
S1=19.3
The yellow highlight
shows the selection.
1
S1=19.3*
Settings
Emissivity
Set Ref
Delete point
Settings
Emissivity
Set Ref
Delete point
Settings
Emissivity
Set Ref
Delete point
Add Spot
0.60
No
No
0.55
Yes
No
0.55
No
Yes
*
*