Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If it is not possible to disconnect all
poles in the supply power, a
disconnection unit with at least 3 mm
contact clearance (fuses, line safety
switches, contactors) must be
connected and all the poles of this
disconnection unit must be adjacent to
(not above) the product in accordance
with IEE directives. Failure to obey this
instruction may cause operational
problems and invalidate the product
warranty.
NOTICE
Additional protection by a residual
current circuit breaker is
recommended.
2. Open the terminal block cover with
a screwdriver.
3. Insert the power cable through the
cable clamp below the terminal and
secure it to the main body with the
integrated screw on cable clamping
component.
4. Connect the cables according to
the supplied diagram.
2NAC 380/400/4 15 V
5. After completing the wire
connections, close the terminal
block cover.
6. Route the power cable so that it will
not contact the product and get
squeezed between the product and
the wall.
і NOTICE
Power cable must not be longer
than 2 m because of safety
reasons.
e
Push the product towards the
kitchen wall.
e
Adjusting the feet of oven
Vibrations during use may cause
cooking vessels to move. This
dangerous situation can be
avoided if the product is level and
balanced.
For your own safety please ensure
the product is level by adjusting
the four feet at the bottom by
turning left or right and align level
with the work top.
Final check
1. Reconnect the product to the
mains.
2. Open gas supply.
Disposal
Disposing of packaging material
Packaging materials are dangerous to
children. Keep packaging materials in
a safe place out of reach of children.
Packaging materials of the product are
manufactured from recyclable
materials. Dispose of them properly
and sort in accordance with recycled
waste instructions. Do not dispose of
them with normal domestic waste.
12 | EN
Werbung
