Connections, Operating And Display Elements - Cameo ZENIT B200 Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
4
1 POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100 - 240 V AC / 50 - 60Hz.
Connection via supplied power cable (when not in use, always close with rubber sealing cap).
2 POWER OUT
IP65 power output socket with rubber sealing cap. Facilitates power supply to other CAMEO lights.
Ensure that the total current consumption of all connected devices does not exceed the value specified
on the device in amperes (A) (when not in use, always close with the rubber sealing cap).
3 ON / OFF
Ensure that the battery is charged sufficiently or connect the lights correctly to the power supply.
Move the switch to the down position to make the floodlight ready for operation. During the start-
up process, "Welcome to Cameo", the model name and the software version will be shown con-
secutively on the display. When the switch is not in the down position, the floodlight is in standby
mode. In both operating states, the battery is constantly being charged, as long as the floodlight is
connected to the power supply correctly.
4 DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console. When not in
use, always close with the rubber sealing cap).
5 DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with
the rubber sealing cap).
6 OLED-DISPLAY
Shows current operating mode, charging status of the battery and the menu items in the edit
menu.
16
7
3
6
7
2
5