ELAC IW1030 Bedienungsanleitung Seite 19

Installation
The result is shown in this picture. The cable ends
4)
with a length of approx. 35-40 cm will come out of
the hole.
5) Separate the twin strands (if you use this type of
cable) between the positive and the negative pole
(see picture).
Remove the insulation of the two wires by means
of the strip-insulation pliers. (You can also use a
sharp knife for this.) Please ensure that the inner
copper wires will not be damaged.
6) Connect the loudspeaker cables to the jacks of the
In-Wall loudspeaker that are on the cabinet.
The correct polarity is important here (marked wire
= positive pole, must be connected to red terminal,
negative pole = must be connected to black
terminal). Press on the terminal and insert the
cables through the hole on the side of the terminal
and release the terminal again.
19