Control Panel - Briteq TORNADO 7 Bedienungsanleitung

ENGLISH
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:

CONTROL PANEL:

1. DMX LED: is lit while the unit receives a DMX-signal. Blinks while performing a software upgrade.
2. W-DMX LED: is lit when the unit receives a wireless DMX-signal and blinks fast while pairing (linking to a
wireless transmitter). The W-DMX led blinks slowly when the transmission is lost.
3. SOUND LED: is lit when the unit is in sound mode.
4. NAVIGATION BUTTONS:
ESC.
DOWN
UP
ENTER
Two button shortcuts make life easier for the installer:
 Press UP & DOWN buttons together for 2 seconds: Display turns over 180°
 Press ESC. + ENTER buttons for 2 seconds: the projector resets.
5. DISPLAY shows the various menus and the selected functions. Depending on the working modes,
different signs will be displayed in the upper right corner:
S
M
D
I
U
V
T
Lock Logo
6. OMEGA CLAMP: on the bottom you can insert the included "omega" quick clamp. Just turn the locking
system over 90° to secure the clamp.
7. SAFETY EYE: used to fix a safety cable for extra security!
8. DMX IN/OUTPUTS: used for DMX512 linking, you can use good quality balanced signal cables with 3pin
XLR-connectors.
9. MAINS CABLE: connect to a suitable mains circuit (100-240V 50/60Hz)
10. FUSE HOLDER: protects the unit, always replace with the same fuse! See technical data for the value.
11. WIRELESS W-DMX-antenna: optionally available module with special antenna that can be used for
wireless DMX-control of the projector. To reduce cost you can daisy chain the other projectors using a
normal DMX-cable.
SETUP MENU - NAVIGATION:
 Press the ENTER button to enter the setup menu.
 Use UP / DOWN buttons to browse the
 Always press the ENTER button to confirm.
 To return to a previous menu, always use the ESC. button.
Note: After 20 seconds the display will automatically return to normal mode without any change.
BRITEQ
®
ESCAPE-button, used to return to a higher menu level.
Press during 3 seconds to lock the setup menu manually.
To go forward in the menu tree or to increase parameters
To go backward in the menu tree or to decrease parameters
To confirm the selected function
Press during 3 seconds to unlock the setup menu when lock function is
activated (small padlock icon in the display)
Unit works in Slave mode
Unit works in Master mode
Unit works in DMX512 Mode
Unit runs the internal Preset Memory
Unit runs the internal User's Memory
Unit runs one of the internal sound programs
Unit runs the Test sequence
Buttons are Locked
submenu(s) and/or select functions, change the value(s).
3/65
USER MANUAL
TORNADO 7