Technical Data; Installation - AEG FROSTIG Bedienungsanleitung

ENGLISH
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.

Technical data

Dimensions for Instal-
lation
Height
Width
Depth
Net Volume
Defrost System
Energy Consumption
Noise Level
Energy Class
Voltage
Frequency

Installation

Caution! Read the "Safety
Information" carefully for your safety
and correct operation of the appliance
before installing the appliance.
Important! Refer to the assembly
instructions for the installation.
Location
To ensure best performance, install the ap-
pliance well away from sources of heat such
as radiators, boilers, direct sunlight etc.
Make sure that air can circulate freely
around the back of the cabinet.
1780 mm
560 mm
550 mm
330 Litre
auto
0,397 kWh/24h
34 dB (A)
A+
230–240 V
50 Hz
Only service is allowed to replace the light-
ing device. Contact your Service Center.
Closing the door
1. Clean the door gaskets.
2. If necessary, replace the defective door
gaskets. Contact the After Sales Service.
The technical infor-
mation are situated
in the rating plate on
the internal left side
of the appliance and
in the energy label.
Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) al-
so, but for optimum performance install this
appliance at a location where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate class
SN
N
ST
T
Ambient tempera-
ture
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
14