or tangled cables increase the risk of electric
shock.
- The appliance is not suitable for outdoor use.
- Supply cord should be regularly examined for
signs of damage, and if the cord is damaged,
the appliance must not be used.
- Do not leave the appliance out in the rain or
exposed to moisture. If water gets into the
appliance, this will increase the risk of electric
shock.
- Do not touch the plug with wet hands.
- Do not use the appliance in the case of persons
insensitive to heat (the appliance has heated
surfaces).
- Do not touch the heated parts of the appliance,
as it may cause serious burns.
- The temperature of the accessible surfaces may
be high when the appliance is in use.
USE AND CARE:
- Fully unroll the appliance's power cable before
each use.
- Do not use the appliance if its feet are not
properly fitted.
- Do not use the appliance if the on/off switch
does not work.
- Do not remove the support feet of the appliance.
- Use the appliance handle, to catch it or move it.
- Do not use the appliance if it is tipped up and do
not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- This appliance is for household use only, not
professional, industrial use.
- Store this appliance out of reach of children
and/or persons with physical, sensory or redu-
ced mental or lack of experience and knowled-
ge.
- Do not store the appliance if it is still hot.
- Do not store the appliance on areas where the
temperature could be lower than 2ºC
- Do not expose the appliance to extreme tempe-
ratures.
- Keep the appliance in a dry, dust-free place, out
of direct sunlight.
- Never leave the appliance unattended when
in use and keep out of the reach of children,
as this is an electrical appliance that heats oil
to high temperatures and may cause serious
burns.
- Do not use the appliance to dry textiles of any
kind.
- CAUTION: User can't sleep when appliance is
under use, there is a risk of injuries.
- Turn the thermostat control to the minimum
(MIN) setting. This does not mean that the
appliance is switched off permanently.
SERVICE:
- CAUTION: There is a risk of fire if the
appliance's cleaning is not done according to
these instructions.
- Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the
manufacturer's liability null and void.
FITTING THE BASE FEET:
- The appliance has anti-slip base feet that sup-
port the product.
- To assemble the base feet, place the appliance
face down.
- Fix the rear support base, fit it tightly against the
fin, until is stays in place
- To fix the front support base, fit it tightly against
the bottom on the front panel.
- Position the base feet on the body of the
appliance.
- Stand the appliance up again so as to check
that the base feet work properly.
INSTRUCTIONS FOR USE
BEFORE USE:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has
been removed.
- To eliminate the smell given off by the appliance
when used for the first time, it is recommended
to have it on at full power for 2 hours in a well-
ventilated room.
USE:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off
switch.
- Turn the thermostat control to the desired tem-
perature position.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Select the minimum position (MIN) using the