Stiga R72 Li 48 V1 Gebrauchsanweisung Seite 101

Attention icon
If icon fig. 7.E is illuminated, it
this indicates failure to comply
with safety conditions or a
possible malfunction of the
machine (see chap. 15).
Battery LED
The LEDs fig. 7.F generally
indicate the charge level of the
machine's batteries but in particular
combinations their lighting status
provides information about machine
malfunctions (see chap. 15).
"Ready" icon
The icon in fig. 7.K is illuminated
when the machine is ON
and ready to be used.
"Bluetooth" icon
The icon in fig. 7.M is illuminated
when the machine and the data
exchange device are connected.
Controller and/or motor
over-temperature icon
The icon in fig. 7.N indicates
overheating of electrical
components. See chap. 15.
Transmission engagement /
disengagement lever icon
The icon in fig. 7.O is illuminated
when the transmission is not
engaged (see par. 6.3 and chap. 15).
Operator on-board icon
The icon in fig. 7.P is illuminated
when operator leaves the
driving seat (see par. 7.2.2).
Emergency pushbutton icon
The icon in fig. 7.Q is illuminated
if the emergency button is
activated (see par. 6.5).
6.8.2 Pushbutton panel (type "II") fig. 7
Machine start button
With the key fully inserted
(fig. 6.A), this button (fig. 7.A) turns
the machine ON and enables
all functions. Activation is
signalled by an audible "beep".
NOTE
If all safety conditions are met,
the "READY" icon comes ON (fig.
7.K) and the machine is ready
to be used (see chap. 7.4).
Cutting means engage and
disengage pushbutton
Press the button fig. 7.B to engage/
disengage the cutting means.
• When the cutting means
are engaged, they become
operational after a few seconds.
• When the cutting means are
disengaged, a brake is applied
simultaneously to stop them
rotating after a few seconds.
NOTE
If the cutting means are engaged
without taking the necessary
safety precautions, the machine
shuts down and cannot be
restarted (see par. 7.2.2)
Reverse gear cutting
enable button
Holding down the button
fig. 7.C gives consent for
reverse mowing.
For reverse cutting, engage the
cutting means and simultaneously
hold down the button.
NOTE
A single buzzer signal indicates the
lack of consent for reverse cutting.
Beacon ON button
Pressing the button fig. 7.D turns
the LED beacon on/off. When
the beacon is ON, icon fig.
7.L is illuminated
EN - 13