Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
5
Arrangement and fitting
5.1 Dimension drawing
5
.2 Installation
The I.S. power supp
ly is to be installed outside of the explosion hazard area
5.3 Mou ting and dismounting
n
Mounting position: any
a) Detachable terminals
All devices are provided w
needed to remove the terminals (as shown in the picture).
b
) Mounting on DIN rails in accordance with EN 50 022
Set the device on the DIN rail and tilt/snap onto the rail a
Do not tilt at an angle to either side when mounting. To dismount, use
a screwdriver to gently pry up the lock on the mounting foot and then
remove the module.
c
) Mounting on DIN rails with an already-installed pac-Bus (only 914
As depicted in the photo, set the device in position on the pac-Bus
(already mounted on the DIN rail) and tilt/snap until it locks in.
Do not tilt at an angle to either side when snapping onto the pac-Bus.
Note: In order to prevent pole reversal during installation, the pac-Bus
elements have been equipped with a keyed connection plug (see photo
The module is fitted with a matching slot.
Dismount as described below in b).
10
I.S. Power Supply Type 9143
ith detachable terminals. A screwdriver is
Screw terminals
Spring clamp terminals
Insulation displacement
terminals
.
s depicted.
3/10-...-...-10)
).
english
Size X
108
mm
128
mm
131
mm
Werbung
Inhaltsverzeichnis
