Einhell bavaria BAS 12 VARIO Bedienungsanleitung Seite 7

Anleitung BAS 12 Vario_SPK1:_
with the set-collar (Figure 3). The correct torque
depends on several factors:
on the type and hardness of material in question
on the type and length screws used
on the requirements needing to be met by the
screwed joint.
The clutch disengages with a grating sound to
indicate when the set torque is reached.
Important! The tool must be at a standstill when
you set the torque with the setting ring.
Drilling
For drilling purposes, move the set-collar to the last
step „Drill". In this setting the slip clutch is inactive.
The maximum torque is available in drilling mode.
Fitting the keyless chuck (Fig. 2)
Unscrew the protective cap (a) from the bit
mount as shown in Figure 2.
Screw the keyless chuck (2) in reverse order
onto the thread of the bit mount (1) and secure
with the screw (b).
Forward/Reverse switch (5)
With the slide switch above the On/Off switch you
can select the direction of rotation of the battery-
powered drill/screwdriver and secure it against being
switched on accidentally. You can choose between
clockwise and anticlockwise rotation. To avoid
causing damage to the gearing it is advisable to
change the direction of rotation only when the tool is
at a standstill. The On/Off switch is blocked when
the slide switch is in centre position.
On/Off switch (6)
Infinitely variable speed control is possible with the
On/Off switch. The further you press the switch, the
higher the speed of the battery-powered
drill/screwdriver.
Screwdriving
We recommend using self-centering screws (e.g.
Torx screws, recessed head screws) designed for
reliable working. Be sure to use a bit that matches
the screw in shape and size. Set the torque, as
described elsewhere in these operating instructions,
to suit the size of screw.
6. Technical data
Voltage supply
Speed
Torque
Forward and reverse rotation
18.01.2007 16:26 Uhr
Chuck clamping width
Battery charging voltage
Battery charging current
Mains voltage for charger
Sound pressure level L
pA
Sound power level L
WA
Vibration a
hv
Weight
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
12 V d.c.
special waste. Ask your dealer or your local council.
0-400 rpm
16 levels
yes
Seite 7
GB
max. 10 mm
12 V d.c.
400 mA
230 V ~ 50 Hz
60,7 dB(A)
71,7 dB(A)
< 2,5 m/s 2
1 kg
7