INVENTOR AR5VI-09WFI/AR5VO-09 Benutzerhandbuch Seite 10

Setting Angle of Air Flow
•
Setting vertical angle of air ow
While the unit is on, use the SWING (up-down)
button on remote control to set the direction
(vertical angle) of air ow. Please refer to the
Remote Control Manual for details.
NOTE ON LOUVER ANGLES
When using COOL or DRY mode, do not set
louver at too vertical an angle for long periods
of time. This can cause water to condense on
the louver blade, which will drop on your floor
or furnishings.
When using COOL or HEAT mode, setting the
louver at too vertical an angle can reduce the
performance of the unit due to restricted air
flow.
Setting horizontal angle of air ow
While the unit is on, use the SWING (left-right)
button on remote control to set the direction
(horizontal angle) of air ow. Please refer to the
Remote Control Manual for details.
ƒPage 10
„
Page 9
ƒ „
NOTE: Do not move louver by hand. This will
cause the louver to become out of sync. If this
occurs, turn off the unit and unplug it for a few
seconds, then restart the unit. This will reset the
louver.
Fig. A
CAUTION
Do not put your ngers in or near the blower
and suction side of the unit. The high-speed
fan inside the unit may cause injury.