HomeMatic HM-PB-2-WM55-2 Montage- Und Bedienungsanleitung Seite 19

The push button supports three different modes:
• Teach mode (teaching HomeMatic components)
• Configuration mode (for changing push button
parameters)
• Operation mode (normal operation)
Teaching requires that both devices to be connected
are put into teach mode. Please see the correspon-
ding manual of the actuator for instructions how to put
the device into teach mode.
• The push button is put into teach mode with the
teach button A.
• The teach button A can be found on the back side
of the electronic unit.
A A
• To reach the teach button, you have to hold both
sides of the electronic unit and pull it out of the
frame.
• Keep a distance of approx. 1 m between the push
36
button and the actuator.
• The push button and the actuator have to be put
into teach mode at the same time:
• Keep the push button on both sides of the rocker.
Press the teach button A shortly. The configuration
mode is indicated with a flashing green device
LED.
• Turn the electronic unit to the front side (see illus-
tration). The arrow on the mounting plate should
point upwards. Press the rocker button shortly.
• The device LED flashes orange.
• Now, the actuator has to be put into teach mode.
• If teaching of rocker buttons is successful, it is
indicated with an illuminated green LED.
• The lower rocker button is defined for the
instructions OFF, DOWN or DARKER and the
upper rocker button for the instructions ON, UP or
37