Assa Abloy OneSystem 309N Montageanleitung Seite 47

Fig. 7 :
Lock type according to
DIN left hand and
DIN right hand
Fig. 8 :
Rotate the control latch
Installation
Adjusting the closing direction of the latch
The closing direction of the lock can be switched for use in DIN left hand and DIN right hand doors (Fig. 7).
For this purpose, the control latch must be rotated before the lock is installed in the door.
DIN left hand
Rotating the control latch
1 Press and hold the latch bolt.
2 Press the control latch.
3 Release the latch bolt while pressing the control latch.
 The deadbolt is no longer relevant and the screw for the control latch can be reached.
2.
3x
3.
3.
4 Unscrew the locking screw with an Allen wrench (Fig. 8).
· Do not unscrew the locking screw entirely.
· Leave the Allen wrench in the bolt head.
1.
5 Pull out the latch.
6 Turn the latch 180 degrees and re-insert it.
7 Fix the latch with the locking screw (torque 0.5 Nm).
1,5 mm
 The latch was installed matching the closing direction of
the door.
4.
DIN right hand
EN
47