Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PROCESS AND DIALOGUE MODULE
■ Panel mounting with clips (snap-in set EC1452)
Preferably select this type of mounting when the unit is to be laid in the horizon-
tal position as it is only held by the force of the clips.
The angle of inclination of the panel must not exceed 45°.
Note when selecting the mounting location:
To loosen the clips the back of the unit must be accessible.
This type of mounting is suited for materials with a thickness of max. 5 mm.
Mounting steps:
Insert clips
Removing the unit from the panel
To insert the screwdriver between the cut-out of the panel and the clip, the
grooved chamfer of the clips must be fitted with a slot.
front
back
24
PAGE
PDM 360
SMART
Press the unit into the cutout
Steps for removal:
1. Insert the screwdriver into the slot of
2. Angle the screwdriver and compress
3. Remove the unit from the cutout.
end position
the clips on the back.
the springs of the clips.
Werbung
