Tintometer Lovibond MD 100 Bedienungsanleitung Seite 40

GB User calibration
F1
On
Off
: :
Store Date
Cal
RESULT RESULT
Time Cal
Zero
Mode
Test
On
Off
Zero
Mode
Test
SEL
CAL
SEL
cAL
Mode
SEL
CAL
On
Off
40
The display shows:
By pressing the [ON/OFF] key, the new correction factor is calculated
and stored in the user calibration software.
Confirmation of calibration (3 seconds).
Factory calibration reset
Resetting the user calibration to the original factory calibration will
reset all methods and ranges.
A user calibrated method is indicated by an arrow while the test result
is displayed.
In order to reset the device to the factory calibration, proceed as follows:
press and and hold both
press briefly, release
release approx. 1 second.
The following messages will appear in turn on the display:
Factory calibration
oder:
User calibration
Calibration is reset to the factory setting by pressing the [MODE] key.
The following messages will appear in turn on the display:
Switch the unit off.
MD1X0/200_1f 05/2023