Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
1. Owner's Liability
• This tool set was developed and manufactured
according to the technical norms and standards
valid at the time and is considered to be opera-
tionally reliable. Nevertheless, the tool set can
present a danger when it is not used as intended
or in an inappropriate way by unqualified personnel.
Please make sure that any person using this tool
or carrying out maintenance work carefully reads
these operating instructions and fully understands
all information given, before using the tool.
• Keep the operating instructions together with the
tool set at all times.
• Any modification of the tool set is strictly forbidden.
• All security advices, warning and operation notices
on the device have to be kept legible. Replace all
damaged labels or stickers.
• All indications concerning setting values and setting
ranges must be observed.
2. Appropriate Use
Operational reliability can only be ensured,
if the tool set is used as intended and in
compliance with the indications given in
the operating instructions.
I n addition to the safety advice given in these ope-
rating instructions, the general safety regulations,
regulations for the prevention of accidents and
regulations for environmental protection being valid
for the application area of this tool set have to be
observed and respected.
Always ensure tools are used, inspected and
maintained in compliance with the respective local,
state, national or federal regulations.
• The tool set must only be used if it is in good work-
ing order.
• All safety equipment must always be within reach
and should be checked regularly.
• The HAZET Silent Block Tool Set is developed for
extracting and inserting the silent blocks located
at the rear axle on:
VW:
Transporter T5
14
For Your Safety
2
Please secure separate parts against falling off!
Please lubricate the threaded spindle before each use!
• For further tool parts see page 15.
• Any deviation from the intended use and/or any
misapplication of the tool set is not allowed and
will be considered as improper use.
• Any claims against the manufacturer and/or its
authorized agents because of damage caused by
improper use of the tool set are void.
• Any personal injury or material losses caused by
improper use of the tool set are the sole respon-
sibility of the owner.
• The spindle 4925-14 has to be lubricated suffi-
ciently before each use.
3. Dangers emanating
from the tool
Before each use, check the HAZET Silent
Block Tool Set for full functional efficiency.
Do not use the HAZET Silent Block Tool
Set if its functional efficiency cannot be
ensured or if damage is detected. If the HAZET
Silent Block Tool Set is used, when it is not in full
working order, you risk severe injuries to persons
and damage to property. Defective tools may
cause severe injury.
• Full functional efficiency is given when:
- the tool set is smooth running
- the tool set is absolutely damage-free.
• The component parts must only be used in com-
bination and as intended.
• When operating the HAZET Silent Block Tool Set,
it is necessary to wear safety glasses and proper-
fitting protective clothing.
• Any service or repair work must be carried out by
qualified personnel only. In order to guarantee long
term operational safety, only original spare parts
must be used.
• For safety reasons any modification of the HAZET
Silent Block Tool Set is strictly forbidden. Any
modification of the HAZET Silent Block Tool Set
will result in immediate exclusion from warranty
and liability.
USA
Werbung
Inhaltsverzeichnis
