Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the tender (Fig. 4). This socket
can be used to provide track
power to cars with lighting or
sound electronics.
To remove the cover of the
socket, pull it straight out. If the
cover is tight, gently use a small
straight screwdriver to pry it out.
(Do not pull out the rectangular
outer housing.)
Smoke Generator
This model is equipped with a
smoke generator. A small supply
of LGB Smoke and Cleaning
Fluid is included with this model.
For best operation, fill the genera-
tor halfway with fluid. If the gene-
rator is overfilled, it will not con-
vert the fluid into smoke.
Attention! Only use LGB Smoke
and Cleaning Fluid (50010).
Other fluids may damage your
locomotive.
Attention! Never touch the hea-
ting element in the center of the
smoke generator. It is fragile.
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of more
than 1 amp. For more information
on LGB power supplies for indoor,
outdoor and multi-train operation,
see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level 1 - Beginner
Level 2 - Intermediate
Level 3 - Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Servi-
ce).
Lubrication 1
The side rod ends should be lubri-
cated occasionally with a small
amount of LGB Maintenance Oil
(50019).
Cleaning 1
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Attention! This model is equip-
ped with sound electronics. Do
not expose the speaker directly to
water.
Replacing the light bulbs 1
Lantern: Pull the lantern housing
away from the model. Pull the
socket out of the housing. Pull the
plug-in bulb out of the socket.
Plug in a new bulb. Reassemble.
Replacing the
smoke generator 2
- Pull the safety cover out of the
smoke stack.
- Use pliers or tweezers to pull the
old smoke generator out of the
stack (Fig. 2).
- Cut the wires to the old genera-
tor and attach them to the repla-
cement generator (Fig. 3).
- Insulate the connections and
push the replacement generator
into the stack.
- Reassemble.
Replacing the traction tire 2
- Use a small, straight-blade scr-
ewdriver to pry the old traction
tire out of the wheel groove.
- Use a small, straight-blade scr-
ewdriver to gently pry the new
traction tire into the wheel groo-
ve.
- Make sure that the traction tire is
seated properly in the wheel
groove.
Maintenance parts
50010 Smoke
Fluid
50019 Maintenance Oil
51020 Gear Lubricant
55020 Multi-Train System Deco-
der
55026 MTS Decoder Interface
Cable
62204 Standard
Long Shaft
63120 Brushes,
14mm and 16mm, 8 pie-
ces
and
Cleaning
Motor
with
Assembled,
9
Werbung
