Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Do not expose the extruder to rain or other liquids.
Make sure that isolating protections (for example gloves) are always
perfectly dry.
Do not expose electrical wiring or hydraulic hoses to chemical substances
or mechanical stress (e.g. pedestrian or vehicular traffic, contact with
sharp objects, pulling, etc.).
Disconnect the power socket outlet from the electrical power supply
when work with the extruder has been concluded or temporarily
suspended. Before using the extruder check the condition of individual
electrical system components, particularly insulating parts, cables, cable
glands and cable jaws.
Clean the extruder thoroughly after each session. Avoid the use of solvent,
petrol and abrasive substances which could damage insulated parts of the
extruder.
Connection cable must agree to regulation and
required power.
Connection must be done with plug IEC 309, IP67. 20
A 230-250V.
Small or humid places, building sites surrounded by metallic masses or
water (for example shipyards) require use of equipment fed in SELV (very
low safety tensions).
Context:
BLOWER, MELTING
CHAMBER AND
WELDING SHOE
RISK OF BURNING
Handle the extruder carefully.
Do not touch welding bead and near areas before complete cooling.
HOT
BURNING AREA
16
EN
FIRE HAZARD
Do not use the extruder in presence of explosive gases and vapors.
Keep away from extruder materials that can deteriorate with heat
inflammable (oil, solvents, etc.).
NIOSE EXPOSURE
USE
PROTECTION
GLOVES
Do not weld sheets, pipes or fittings that contain or have previously
contained toxic substances.
Use carefully those chemical substances used during preparations before
welding:
Stay away from flames or hot surfaces;
Do not smoke;
Ventilate the work place.
Context: MOTOR AND BLOWER
Context:
MOTOR
Context: SHEETS/PIPES/FITTINGS
CHEMICAL HAZARDS
OTHER FABRICATION MATERIALS
RISK OF EXPLOSION
WEAR EARMUFFS
Werbung
