Werbung
Verfügbare Sprachen
Verfügbare Sprachen
This product is a so-called showlaser, emitting radiation in a wavelength spectrum between 400 and 700 nm
and producing lighting effects for shows.
Operating a laser product may lead to permanent injury of persons. Please refer to the explanations under
"Legal instructions" and "Protective measures for a safe operation".
Keep away from heaters and other heating sources!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never direct the laser beam to people or animals.
CAUTION LASER DIODE: never unscrew the housing!
Never leave this device running unattended.
Always disconnect from the mains when the device is not in use or before cleaning it.
Keep away children and amateurs from the device!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
3. OPERATING DETERMINATIONS
Areas of use
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
This laser must only be used for shows. The operation of a class 3B showlaser is only allowed if the
operation is controlled by a laser safety officer.
Teenagers older than 16 years can only be employed in laser areas if necessary for completing their job
training and if their protection is guaranteed by a skilled person.
This device is designed for mobile use and for permanent installations.
Laser effects are not designed for permanent operation. Consistent operation breaks will ensure that the
device will serve you for a long time without defects.
This product was designed for indoor use only.
The ambient temperature must always be between +10° C and +35° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 35° C.
This device must only be operated in an altitude between -20 m and 2000 m over NN.
The protections must only be proyected in the blocked showlaser area. Please refer to the explanations
under showlaser area.
17/26
00054554.DOC, Version 1.0
Werbung
