Operation - Kärcher STH 5.56 W Originalbetriebsanleitung

Adjust the machine to suit the snow
and ground conditions
Adjusting the skids
Figure 4
The landing skids (1) can be used to adjust
the distance between the ground and the
clearing plate (4) in such a way that no
parts of the ground (such as soil or stones)
are picked up.
 Loosen the nuts (2) on both the sides of
the appliance.
 Adjust the landing skids according to
the underground surface: Set it lower
for uneven or loose parths; higher for
even roads and paths.
 Fasten the landing skids with nuts (2) in
such a way that they uniformly touch
the ground from the bottom.

Operation

Safety instructions
Danger
Risk of injury!
Keeps persons, especially children,
–
and pets away from the hazardous
zones.
Operate the machine only in a safe and
–
perfect working condition.
Always observe the safety distance to
–
the circling tool prescribed by the guide
bar.
Check the area where the machine is to
–
be used and remove all objects that can
get picked up and thrown out by the ma-
chine.
Work only with adequate lighting.
–
Only use the machine in walking speed.
–
Work slowly and safely especially on
–
uneven or loose paths and while revers-
ing.
Adjust the distance between the snail
–
casing and the underground floor in
such a way that the appliance does not
pick up any foreign bodies (such as
stones).
Danger
Risk of suffocation on account of carbon
monoxide! Only operate the combustion
engine while out in the open.
Danger
Risk of fire! Keep the motor and exhaust
free of dirt and escaping oil.
Note: Follow the national/ local regulations
for the usage times (ask the local authori-
ties, if required).
Safety information about appliances
Danger
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
Proneness to blood circulation deficien-
–
cies (cold, numb fingers).
Low ambient temperature. Wear warm
–
gloves to protect hands.
A firm grip impedes blood circulation.
–
Continuous operation is worse than an
–
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
Tips for clearing the snow
Clear up immediately after the snowfall;
–
otherwise, the lower layer becomes ice
and makes clearing difficult.
If possible, clear the snow in the direc-
–
tion of the wind.
Clear the snow in such a way that the
–
clearing tracks overlap a little.
Working on slopes
Danger
Risk of injury!
Danger of tipping if gradient is too high.
Do not use the appliance on slopes with
–
an inclination greater than 20%.
Work slowly and cautiously, especially
–
while changing the direction of travel.
Drive up and down the slope - never di-
–
agonally to the slope.
Pay attention to hurdles - do not work
–
close to the inclination.
Setting the direction and distance of
throw
Figure 6
Danger
Risk of injury! Do not direct the flap (2) of
the discharge shaft (3) towards persons,
animals, windows, cars and doors.
3
-
EN
Adjust throw direction
 Bring the discharge shaft (3) to the de-
sired direction by turning the crank (fig-
ure 1, item 5).
Adjust the throw distance
Deeper the flap (2), so much higher and far-
ther will be the snow discharge.
 Loosen the wing nut (1) and adjust the
flap (2) higher/ lower as required.
Start the engine
Figure 3
 Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
 Release the clutch lever for the auger
drive and travel drive before starting.
 Check tank contents and oil level; refill
oil and fuel (see "Engine Instructions
Booklet").
Starting using rope starter
 Insert the ignition plug into the spark
plug.
 Set the gas lever to "fast".
 Set the choke for cold start to "ON/
CHOKE".
 Insert the ignition key into the ignition
lock, do not turn it.
 Press cold start help (Tupfer) once;
press it twice to seven times during cold
weather (depending on the engine
type).
 Pull the rope starter slowly till you feel
the resistance and then give it a quick
and hard tug. Do not allow the rope
starter to recoil immediately - just let it
go back slowly.
 Reset the choke back to "RUN/OFF" in
a step-by-step manner, if the engine is
running.
Putting/ changing gears
Figure 1
Caution
Release the clutch lever for snail and travel
drive before putting or changing a gear.
Select the gear using the switch lever:
 Forward: "1" (slow) to "5" (fast)
 Reverse: R1 slow/R2 fast
13