Herunterladen Inhalt Inhalt Diese Seite drucken

Control And Setting - Sonnenkönig FASSSAUNA Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

05 - CONTROL AND SETTING

Turning On and Off the Sauna Heater
When the heater is connected to the power
source, and the power switch (located at the
front of the control panel behind the protective
cover at the bottom of the front of the heater) is
in the „On" position (Position 1), the heater is in
standby mode (the indicator light on the I/O
switch is lit).
Press the I/O button on the
control panel to turn on the
heater.
You will hear a clicking sound to indicate that the
safety switch is activated. Once the heater is tur-
ned on, signal light 6 will flash, and the display
will show the set temperature. After five seconds,
the display will show the current temperature in-
side the sauna. When the desired temperature in
the sauna has been reached, the heating ele-
ments will automatically turn off. To maintain
the desired temperature, the control unit will pe-
riodically turn the heating elements on and off.
The last decimal point on the display will light up
when the heating elements are on. The heater
will turn off when you press the I/O button again,
when the set timer has expired, or if an error oc-
curs.
EN
62
1. Display
2. Oven on/off switch
3. Change mode
4. Decrease value *)
5. Increase value *)
6. Temperature control light
7. Time selection indicator light
Fig. 2
*) Keep pressed so that the values
change more quickly.
Sauna Heater Control
Through the control panel of the heater, sauna
temperature and operating time can be individu-
ally adjusted by each user as desired (see Fig. 2).
The heater can also be programmed to turn on at
a specific time using a button on the control pa-
nel. The factory settings for the heater are as
follows:
• Temperature: +80°C
• Operating Time: 4 hours
• Preheat Time: 0 hours

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis