Kärcher KM 85/50 R Bp Pack 2SB Bedienungsanleitung Seite 26

Checking the main fuse
Main fuse, 125 A
1
Positive terminal connection
2
Terminal cover
3
1. Remove the terminal cover.
2. Check the main fuse.
3. If the main fuse is faulty, there are various possible causes. In
such a case, contact Customer Service.
Check the main fuse (KM 85/50 R Bp pack)
Terminal nut
1
Note
Tightening torque 6 Nm
Main fuse, 125 A
2
Battery terminal, plus terminal
3
Note
Tightening torque 8 Nm
1. Open terminal nut.
2. Check the main fuse.
3. If the main fuse is faulty, there are various possible causes. In
such a case, contact Customer Service.
26
Fuses
Jack
1
Rear wheel
2
Washer
3
Screw
4
Sleeve
5
1. Unfasten the screw a little, do not completely unscrew it.
2. Lift the device with the jack at the attachment point.
3. Unscrew the screw, remove the washer from the sleeve.
4. Remove the rear wheel from the axle.
5. Put on a new rear wheel and tighten the screw, washer and
sleeve.
Beware of the feather key!
Replacing the front wheel
Front wheel
1
Nut and washer
2
Wheel fork
3
Attachment point for jack
4
1. Unfasten the nut on the left and right front wheels a little (do
not unscrew completely).
2. Raise the device 6-8 cm at the attachment point, and support
it.
3. Remove the front wheel with the axle downwards.
4. Insert a new front wheel into the wheel fork and tighten it.
The washer is placed between the wheel fork and the nut.
Checking the tyre pressure
CAUTION
Never exceed the maximum permissible tyre filling pressure.
1. See the "Technical data" for the tyre pressure.
English
Replacing the rear wheel