Reinstalling The Battery; Charging The Battery - SHERCO 250 SEF RACING Benutzerhandbuch

ELECTRICAL SYSTEM MAINTENANCE

REINSTALLING THE BATTERY

2
1

CHARGING THE BATTERY

130
- Insert the battery into place.
- Connect the positive cable to the battery.
- Connect the negative cable to the battery.
3
- Install the battery retaining bracket and tighten the
two screws
Chassis screws
- Check the positioning of the battery cables to make
sure that they do not interfere with the installation
of the air filter.
- Replace the air filter (& p.112).
- Replace the seat (& p.112).
The battery is a maintenance-free type. If the vehicle
is not used for an extended period, it is recommended
that the battery be disconnected and stored in a dry
place. See removing the battery (& p.129).
Check the voltage of the battery with a voltmeter:
Battery voltage
If battery voltage is too low, remove the battery from
the bike and charge it using a special chager suited
to lithium batteries.
Disconnect the charger after charging.
Install the battery (
.
1
above).
M6 10Nm
>12.5V