Herunterladen Diese Seite drucken

cecotec CONGA WINDROID 880 SPRAYWATER CONNECTED T Bedienungsanleitung Seite 52

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 66
ENGLISH
Cleaning instructions
Step 1. Dry cleaning Fig. 7
-
For the first use, you must use the "dry mode". Do not activate the spray mode or spray
water/glass cleaner. If the surface to be cleaned has too much sand, remove the sand
previously.
-
If the surface to be cleaned has a lot of sand, it could form mud when spraying. Cleaning
would not have an optimum result.
-
If you use the machine on sunny days or with low humidity, the dry mode will get better
results.
Step 2. Spraying mode Fig. 8
-
Choose the spraying mode. Select the automatic or manual cleaning mode, according to
the desired spraying frequency or the areas to be cleaned.
-
Remember that if the device cloths are too wet, you may not get the desired cleaning
result. It is recommended to slightly moisten them.
4. CLEANING AND MAINTENANCE
-
Use a soft, damp cloth to clean the product's outside surface.
-
The cleaning cloths are washable and reusable.
-
Do not immerse the product in water or put it under running water.
-
Do not expose the robot to direct sunlight or high temperatures.
5. TROUBLESHOOTING
Problem
The robot slips and cannot detect
the upper window frame in Auto up
and down mode.
The robot does not finish cleaning
the whole window and stops in the
middle.
The robot does not move smoothly
or moves irregularly.
52
Press stop
and select the left-down cleaning
mode
to continue cleaning.
Press left and right buttons to continue cleaning.
The cleaning cloth is too dirty. Clean it or replace it.
Remove stickers or films on the window.
The screw on the cleaning wheel is loose, tighten it.
Cause

Werbung

loading