Flex MT 18.0-EC C Bedienungsanleitung Seite 13

Symbols used in this manual
WARNING!
Denotes impending danger. Non-observance
of this warning may result in death or
extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in slight
injury or damage to property.
NOTE
Denotes application tips and important
information.
Symbols on the power tool
V Volts
/min Rotation rate
To reduce the risk of injury, read the
operating instructions!
Disposal information for the old
machine (see page 19)!
For your safety
WARNING!
Before using the power tool, please read and
follow:
these operating instructions,
the "General safety instructions" on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged.
The multi tool may be used only
as intended,
in perfect working order.
Faults which impair safety must be repaired
immediately.
14
Intended use
The multi tool is designed
– for commercial use in industry and trade,
– for plunge cut in wood, plastics and soft
(non-ferrous) metals .
– for sanding (not for plaster/drywalls) and
scraping by using appropriate accessories.
Safety warnings for multi tool
WARNING!
Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow
all instructions listed below may result in
electric shock, fire and/or serious injury. Save
all warnings and instructions for future
reference.
■ Hold power tools by insulated gripping
surfaces when performing an operation
where the cutting tool may contact hidden
wiring. Contact with a "live" wire will make
exposed metal parts of the tool "live"
could give the operator an electric shock.
■ Take protective measures when dust can
develop during working that is harmful
to one's health, combustible or explosive.
Example: Some dusts are regarded as
carcinogenic. Wear a dust mask and
work with dust/chip extraction when
connectable.
■ Use the machine only for dry sanding.
Penetration of water into the machine
increases the risk of an electric shock.
■ Secure the workpiece. A workpiece
clamped with clamping devices or in a vice
is held more secure than by hand.
■ Wear protective gloves when changing
cutting tools. Cutting tools become hot
after prolonged usage.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 62841.
The evaluated noise level of the power tool is
typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
– Total vibration value
– Emission value a
MT 18.0-EC
: 77.03 dB(A);
pA
: 88.03 dB(A);
WA
K = 3 dB.
(cutting boards):
h,B
< 1.28 m/s 2