Installing The Batteries; Mounting The Remote Receivers Antenna Polarization - Spektrum AR12110 Bedienungsanleitung

EN
Installing the PowerSafe Main Unit
1. Using foam or thick double-sided foam tape and tie wraps, secure the
main PowerSafe unit in the position where you would normally mount the
receiver.
2. Mount the switch on the side of your aircraft and insert the switch plug in the
port in the main unit marked SWITCH.
NOTICE: The PowerSafe uses a specifically designed switch. Conventionally wired
switches are not compatible with the SmartSafe.

Installing the Batteries

Using the given guidelines select the battery system that best fits your application
and install the battery(s)/regulator(s) in your aircraft. Connect the battery to the Po-
werSafe. Spektrum batteries are pre-wired with an EC3 connector and plug directly
in. If using another brand of battery it will be necessary to solder EC3 connectors
(two are included with the AR12110) to the battery leads. If using a regulator, install
it per the guidelines included with the regulator.
Mounting the Remote Receivers
Antenna Polarization
For optimum RF link performance, it' s important that the remote antennas be
mounted in an orientation that allows for the best possible signal reception when
the aircraft is at all possible attitudes and positions. This is known as antenna
polarization. This allows the greatest exposed visual cross-section of the antennas
from all aircraft orientations. If three antennas are used, it is recommended that
one antenna be mounted vertically, one horizontally in-line with the fuselage and
12