Display And Operating Elements - MTR+ RehaBravo Bedienungsanleitung

RehaBravo Bedienungsanleitung / Operators Manual

Display and Operating Elements

„ON/OFF": By pressing the button once, the device will either be switched
on or off.
„+/- buttons": This button regulates the intensity for the channels A and B.
The device also has two independently controllable output channels A and B.
When pressing the respective arrow buttons the intensity will either be
increased or decreased. 60 seconds after the last intensity regulation, a further
increase is may not be carried out due to an electronic barrier. But if the „+"
button is pressed three times, the barrier is released and the intensity can be
altered again. A reduction of the intensity is possible at any time.
Whilst configuring the programmes 16 - 18 one switches between the
programmable parameters by pressing the left „+/-„ button (channel A), and
through pressing the right „+/-„ button (channel B) the desired value/data for
respective parameter can be set. In this way, the application time, the
stimulation, the pause, rising pulse and falling pulse, as well as synchronous or
asynchronous stimulation can be selected.
„PRG": With this button the preset programmes 01 – 15 or the three free
programmable programmes 16 - 18 can be selected for individual use. In addi-
tion, this button stores the current adjustment in the programming mode and
ends it.
„SET": With the SET-button one can select the different programme phases.
With every pressing of this button, the phase in progress is terminated the next
programme phase is started. This applies to either the running of the
programmes 01 – 15 and also to the programming and the sequence of
programmes 16 – 18. If one keeps the SET-button pressed for 3 seconds
whilst being in programmes 16 – 18, the programming part of the programme is
then entered.
39